Printrbot Extruder

-

An item for a friend, apparently the standard extruder head on the printr bot is not fantastic, this replacement extruder should help improve that.
362/350


Popular posts from this blog

Laser cutter speed difference

-
Image
Here is the video of my two laser cutters cutting the same tile side by side. It prompted a few people to ask 'how come the 30W tube is much faster than the 100W tube?' I picked the new laser cutter  based upon speed. It had a few specification stats that suggested it was fast and the photos showed a fairly lightweight head etc. Now that I have the laser in my possession I can see all the design decisions that make it fast. In the case of these Carcassonne tiles  I only need the full power of the laser when I'm cutting the tiles out. The low power engraving lines are done with minimal power, only 8% of the 30W tube. The metal RF tube gives me much more control over the low end power, the head can fly around at 100mm/s, twice the speed of the larger machine. The engraving can be done at 1000mm/s, again nearly twice the speed and empirical evidence suggests that it is actually moving at that speed. The 30W laser can easily handle the 3mm poplar ply wood at a sensible 3...
Read more

Mimic Business Card Holder

-
Image
Northants Board Game convention is right around the corner and I'm exhibiting this year so I decided I needed a better business card holder to dish out my little business tchotchke. I found a file for a mimic box that I liked and modified it to come up with this little cutie. He's a very happy chappy, just be careful of your fingers when you're taking a card.  
Read more

Wiring the Ruida Controller

-
Image
The RDC6442G controller from Ruida This is going to be quite an image heavy post describing the rewiring needed to convert between the Leetro controller and the Ruida controller. It is also pretty straight forward on the old Just Add Sharks laser cutters because all of the wires are clearly labelled. The controller was prepared in the previous step in order to make this conversion process as smooth as possible. The Leetro (Pad03) panel on the left and the Ruida panel on the right The view from inside the laser looking up at the control panel The control panel is an easy place to start, both panels have just a single cable that runs down to the controller, both panels are a very similar size, with the Ruida panel being slightly smaller underneath so it will fit in the hole left behind easily. The Pad03 panel clips into place so you'll need to reach up inside the machine to work the clips loose. The cable runs down the inside of the laser and is cable tied onto mounti...
Read more