MSRaynsford

I've had these 15mm bubble rods from Kitronik  for quite a long time, I thought they would look good when side lit. I used a single neopixel on each end of the rod and illuminated both ends with the same colour. The colours slowly fade on/off and at different frequencies. 22mm copper pipe fittings make perfect end caps and the the laser cut adaptors to go between the two.

These demonic seals were cut in ye olde MDF for that genuinely realistic appeal. The disks were painted with metallic acrylic before engraving so it was easy to wipe the dust off. These seals were going to be used as decoration on the vale machine (and were made way back in May)

Just a sample for a coaster, I masked the acrylic with vinyl transfer tape before engraving to ensure that I got a good clean cut. I didn't realise it was a coaster otherwise I would have rounded the edges and engraved it on the reverse so that the engraving was on the underside and less prone to damage during use.

This chits were made for the LRP Game, Age of Aether . I believe the top disk is copper, silver or gold and the larger bottom disk is red, green or blue to denote different groups and weightings. I would normally paint a sheet before cutting but because the exact combinations required were unknown I left them all blank.