Panel Joinery 28

-

Several bulb joints can be connected in line to fold right back over itself
269/282





Popular posts from this blog

Wiring the Ruida Controller

-
Image
The RDC6442G controller from Ruida This is going to be quite an image heavy post describing the rewiring needed to convert between the Leetro controller and the Ruida controller. It is also pretty straight forward on the old Just Add Sharks laser cutters because all of the wires are clearly labelled. The controller was prepared in the previous step in order to make this conversion process as smooth as possible. The Leetro (Pad03) panel on the left and the Ruida panel on the right The view from inside the laser looking up at the control panel The control panel is an easy place to start, both panels have just a single cable that runs down to the controller, both panels are a very similar size, with the Ruida panel being slightly smaller underneath so it will fit in the hole left behind easily. The Pad03 panel clips into place so you'll need to reach up inside the machine to work the clips loose. The cable runs down the inside of the laser and is cable tied onto mounti...
Read more

Testing the Ruida Controller

-
Image
So far in this series of blog posts I've talked about setting up the ruida controller and wiring it into the laser cutter , now is the point where it needs to be tested to ensure that it actually works as intended. In the previous post I failed to mention that the power connector needs to be rewired but it's a straight forward swap of GND and +24V. Once the controller can actually be turned on we're ready to start testing. Testing Automatic Features Safety is all important while testing the machine, there are moving parts and laser beams during this whole process so care should be taken. The big red emergency stop on the machine is always close to hand, the key switch similar. The safety interlock lid switch for the laser is still wired directly to the high voltage power supply so the laser will not fire with the lid open or the water pump off. The first test is to ensure that both axis move in the correct direction. The controller was set up to initia...
Read more

Leetro to Ruida Settings

-
Image
The first step towards upgrading a leetro based machine is to acquire a replacement controller. I opted for the Ruida 6442G  to make it the same as my other machine. I bought my controller through ali express from Cloudray , it's currently $266 USD for delivery to the UK it took 3 weeks to arrive and cost around £250 GBP once customs and duty had been paid on it. I would probably recommend buying it through cloudray ebay instead, it's £260 but it'll arrive within a few days. Cloudray  is my current part supplier, they've been pretty good so far. A delay suited me nicely with the Christmas rush on fractal puzzles and other products. The kit of parts as it arrived was very complete. The controller and the screen were protected with bubble wrap and anti-static bags. Other parts include two USB cables to go from the controller to the edge of the laser, one for USB sticks, one for the laptop connection. An Ethernet extension to go the the edge of the laser and al...
Read more