Quick and Cheap Stencils

-

Ape Index wanted some more quick and easy stencils which I'm happy to do, especially if the material is cheap. As these are only going to be used two or three times it doesn't make sense to do them in mylar so I recycled some of the cardboard boxes that my Kitronik orders came in to flat sheets perfect for this use. Free is a perfect price for a job like this, my only trouble will now be carrying large flat sheets into town as part of my daily exercise :)




Popular posts from this blog

Wiring the Ruida Controller

-
Image
The RDC6442G controller from Ruida This is going to be quite an image heavy post describing the rewiring needed to convert between the Leetro controller and the Ruida controller. It is also pretty straight forward on the old Just Add Sharks laser cutters because all of the wires are clearly labelled. The controller was prepared in the previous step in order to make this conversion process as smooth as possible. The Leetro (Pad03) panel on the left and the Ruida panel on the right The view from inside the laser looking up at the control panel The control panel is an easy place to start, both panels have just a single cable that runs down to the controller, both panels are a very similar size, with the Ruida panel being slightly smaller underneath so it will fit in the hole left behind easily. The Pad03 panel clips into place so you'll need to reach up inside the machine to work the clips loose. The cable runs down the inside of the laser and is cable tied onto mounti
Read more

Rainbow Puzzle Box

-
Image
This is a binary sequence puzzle box built from 3mm birch plywood, it uses a Gray code pattern to ultimately align all the dials into a rainbow pattern before the lid can be removed. It's actually a redesign of a puzzle inside Loki's box of Tricks  because I thought it would make a cool stand alone puzzle box. The files are available for sale in my Etsy store . ( svg here ) The puzzle consists of five interlocking disks that can only rotate when the disks either side of it are in the correct position to allow it. The large wheel in the middle and the disks on the underside of the lid further restrict the rotation of the disks. The large wheel must be pointed to the disk that is being rotated and the large wheel is in turn restricted from pointing to the smaller disks depending on alignment. Once all the disks are aligned into the full rainbow the large wheel is completely free to rotate and can be turned to the edge of the box and allows the lid to be removed. There is a very
Read more

Working Dice Tower (with plans)

-
Image
The final challenge for the dice tower was to make the baffles stay in the tower when picked up and to make them extend into the new catchment tray. The solution came in the form of a living hinge, a small flexible section at the bottom of the baffles that could slide out into the tray. Small lips on either side stop the baffles from falling out of the tower, but are small enough that the tower can still fold flat. I'm sure there are many things that could be improved upon so please let me know if you build one or make any changes ( svg here ) 
Read more